External Clocking Ports Specifications On The Acx1000 And Acx1100 Router; Management Port Connector Pinout Information For Acx Series Routers; Table 28: Management Port Connector Pinout Information - Juniper ACX1000 Hardware Manual

External Clocking Ports Specifications on the ACX1000 and ACX1100 Router

Related
Documentation

Management Port Connector Pinout Information for ACX Series Routers

Related
Documentation
Copyright © 2013, Juniper Networks, Inc.
The external clocking port on the ACX1000 and ACX1100 router contains four SMB
connectors that support 10 MHz GPS and 1 pulse-per-second (PPS) signals. These signals
are internally isolated and have surge protection. Use a Molex 50-ohm SMB connector
or equivalent (not provided) to connect to the external clocking ports.
ACX1000 and ACX1100 Universal Access Router Overview on page 3
Front Panel of an ACX1000 Router on page 9
LEDs on ACX1000 and ACX1100 Routers on page 12
Clocking Ports on the ACX1000 and ACX1100 Router on page 19
The management port on an ACX Series router labeled
to connect to a management device for out-of-band management.
The port uses an autosensing RJ-45 connector to support a 10/100Base-T connection.
Two LEDs indicate link/activity on the port and the administrative status of the port.
Table 28 on page 133 provides the pinout information for the RJ-45 connector for the
management port.

Table 28: Management Port Connector Pinout Information

Pin Description
1 TRD[0]-
2 TRD[0]+
3 TRD[1]-
4 TRD[1]+
5 TRD[2]-
6 TRD[2]+
7 TRD[3]-
8 TRD[3]+
Console/Auxiliary Port Connector Pinout on ACX Series Routers on page 134
Appendix F: ACX1000 and ACX1100 Cable Connector Pinouts
MGMT uses an RJ-45 connector
Direction
In/Out
In/Out
In/Out
In/Out
In/Out
In/Out
In/Out
In/Out
133