Acx1000 And Acx1100 Dc Power Specifications; Table 25: Dc Power Electrical Specifications - Juniper ACX1000 Hardware Manual

Related
Documentation

ACX1000 and ACX1100 DC Power Specifications

Copyright © 2013, Juniper Networks, Inc.
Appendix D: Power Guidelines, Requirements, and Specifications for the ACX1000 and ACX1100 Router
WARNING: The AC power cord for the router is intended for use with the
router only and not for any other use.
WARNING: The attached power cable is only for this product. Do not use the
cable for another product. Translation in Japanese follows:
NOTE: In North America, AC power cords must not exceed approximately
14.75 ft (4.5 m) in length, to comply with National Electrical Code (NEC)
Sections 400-8 (NFPA 75, 5-2.2) and 210-52, and Canadian Electrical Code
(CEC) Section 4-010(3). You can order AC power cords that are in compliance.
CAUTION: Power cords and cables must not block access to device
components or drape where people could trip on them.
ACX1100 AC Power Specifications on page 123
The power supplies in ACX1000 and ACX1100 routers are built in along the front left
panel of the chassis with DC power terminals to connect power to the router. The power
supplies are labeled and
PS0
ACX1000 and ACX1100 routers support a wide range of voltage ranges as shown in
25 on page 125.

Table 25: DC Power Electrical Specifications

Item
DC input voltages
.
PS1
Specification
18 to 30 VDC
–39 to –56 VDC
–39 to –72 VDC
Table
125