Ipv4 Routing Commands - NETGEAR ProSafe SRX5308 Cli Reference Manual

net qos profile enable <row id>
This command enables a WAN QoS profile by specifying its row ID.
Format
net qos profile enable <row id>
Mode net
Related show command:

IPv4 Routing Commands

net routing static ipv4 configure <route name>
This command configures an IPv4 static route. After you have issued the net routing
static ipv4 configure command to specify the name of the new route, you enter the
net-config [static-routing-ipv4] mode, and then you can configure one keyword and
associated parameter or associated keyword at a time in the order that you prefer.
Step 1 Format
Mode
Step 2 Format
Mode
Keyword
active_flag
private_flag
destination_address ipaddress
subnet_mask
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
show net qos setup
net routing static ipv4 configure <route name>
net
active_flag {Y | N}
private_flag {Y | N}
destination_address <ipaddress>
subnet_mask <subnet mask>
interface {custom_vlan <VLAN name> | dmz | lan | wan {WAN1 | WAN2
| WAN3 | WAN4}}
gateway_address <ipaddress>
metric <number>
net-config [static-routing-ipv4]
Associated Keyword to Select
or Parameter to Type
Y or N
Y or N
subnet mask
Net Mode Configuration Commands
Description
Specifies whether or not the route is an active
route.
Specifies whether or not the route can be shared
with other gateways when RIP is enabled.
The destination IP address.
The destination subnet mask.
93