Policy-Aggregate - Dell S4810 Reference Manual

policy-aggregate

Allow an aggregate method of configuring per-port QoS via policy maps. An aggregate QoS policy is part
of the policy map (output) applied on an interface.
S4810
Syntax
policy-aggregate qos-policy-name
To remove a policy aggregate configuration, use the no policy-aggregate
qos-policy-name command.
Parameters
qos-policy-
name
Defaults none
Command CONFIGURATION (policy-map-input and policy-map-output)
Modes
This command is supported on S-Series, S6000 and S4810 under policy-map-
input mode only.
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.2.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.1
Related
policy-map-input
Commands
policy-map-output
Quality of Service (QoS)
Enter the name of the policy map in character format (32
characters maximum).
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Policy name character limit increased from 16 to 32.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— creates an input policy map.
— creates an output policy map (E-Series Only).
1357