Table of Contents
Advertisement
Chapter 9 Operational Settings
Setting the Waiting Time to Enter Power Saving
Mode [Power saving]
When the scanner is not being used for a certain period of
time, it enters power saving mode to save the power
consumption.
1
Start up the Software Operation Panel.
Refer to
"9.1 Starting Up the Software Operation Panel" (page
2
From the listing on the left, select [Device Setting].
3
Use the slide bar to specify the waiting time to enter
power saving mode.
It can be set in the range of 5 to 235 minutes (in increments of
5 minutes).
170).
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
215
Advertisement
Table of Contents
Troubleshooting
