Table of Contents
Advertisement
Chapter 9 Operational Settings
Sounding an Alarm When an Error Occurs
[Alarm setting]
Specify whether or not to beep an alarm sound when a paper
jam or multifeed occurs.
1
Start up the Software Operation Panel.
Refer to
"9.1 Starting Up the Software Operation Panel" (page
2
From the listing on the left, select [Device Setting 2]
[Alarm setting].
3
Configure settings for alarm.
Disable alarm:
Low volume alarm: Beeps the alarm in small volume when an
High volume alarm: Beeps the alarm in large volume when an
170).
This setting can also be configured from the operator
panel.
No alarm beeps even when an error occurs.
error occurs.
error occurs.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
199
Advertisement
Table of Contents
Troubleshooting
