Konica Minolta Fujitsu fi-6800 Operating Manual page 113

Chapter 5 Various Ways to Scan
When the [Show multifeed image] check box is selected,
it displays a dialog box where you can check the image(s)
that multifeed was detected on.
Scanned image(front side), scanned image(back side)
Shows the multifeed image(s).
[OK] button
Keeps the image and continues scanning. To have the
multifeed pattern memorized, you need to select the
[Auto-Memorize MF Pattern (only when MF images
are displayed)] check box in the iMFF settings
described in "Specifying an Area Not to Detect
Multifeed [Intelligent Multifeed Function]" (page 213)
the Software Operation Panel beforehand.
You can change whether or not to detect multifeed by
pressing the [iMFF] button on the operator panel.
When you use the operator panel, priority is given to
the multifeed pattern memory setting of the operator
panel.
[Rescan] button
Continues scanning after setting the documents on the
hopper again.
[Cancel] button
Discards the multifeed image and stops the scan. Note
that images up until the detection of multifeed are kept.
5
Click the [OK] button.
It returns to the [TWAIN Driver (32)] dialog box.
6
Click the [OK] button in the [TWAIN Driver (32)] dialog
box.
The settings are saved.
7
Perform a scan from ScandAll PRO.
For information on how to perform scanning, refer to "How to Use
ScandAll PRO".
TOP
Contents
Index
Introduction
Scanner
Overview
of
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
113