Konica Minolta Fujitsu fi-6800 Operating Manual page 180

Chapter 9 Operational Settings
Item Description
Paper Protection You can specify the level of
Sensitivity sensitivity to detect an abnormal
feeding of documents when Paper
Protection is enabled.
It can also be configured from the
operator panel. Note that you can
prioritize the operator panel setting.
Scan Setting for For documents with index tabs or
Document with Tab index stickers attached on the
(Automatic Page bottom of the page, you can keep
Size Detection) the tab (index or index stickers) on
the scanned image when scanning
in Automatic Page Size Detection.
Specifying [Document with tab]
shows the image of the tab, but
slows down the scanning speed.
Scan Setting for Configure this setting when the
Document in Dark edges of a document with dark
Background Color background color are falsely
detected. You can specify the level
of sensitivity to accurately detect the
edges of documents with dark
backgrounds.
Overcrop/ Adjust the size of the scanned
Undercrop document output image detected in
Automatic Page Size Detection.
Setting/Value
Low / Normal / High
SCSI or USB Connector 1:
Document with tab / Document without
tab / Non-rectangular document
SCSI or USB Connector 2:
Document with tab / Document without
tab
Enable / Disable
Density of background color: Level 1 to 5
Overcrop: 0 to 5 mm
(in increments of 1 mm)
Undercrop: -5 to 0 mm
(in increments of 1 mm)
Factory Default SCSI or USB
Connector 1
: Configurable
-: Not configurable
Normal
Document
without tab
Disable -
0 mm -
TOP
Contents
SCSI or USB
Index
Connector 2
Introduction
Scanner
Overview
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
180