Chapter 5 Various Ways to Scan
Bypassing Multifeed Detection for a Fixed Format
If you attempt to scan a document sheet with a sticky note,
receipt, or photo glued on it while the Multifeed Detection
function is enabled, the scanner may falsely judge this as a
multifeed error and discontinue the scanning. To scan these
types of documents, the "Intelligent Multifeed Function" is
available.
There are two modes to this function. In one mode, you can
suppress multifeeds forcibly by using the operator panel on
the scanner. In the other mode, you can suppress multifeeds
automatically by letting the scanner memorize the locations
and the sizes of the attachment.
Sticky note
Receipt
or photograph
Document
Intelligent Multifeed Function
The following three modes are available:
Mode
Manual mode (Bypass
Checks for any papers attached every time a
by front panel button)
multifeed occurs, and continues scanning.
Auto mode 1 (Bypass
Used to scan a document stack with paper of
by combination of
the same size attached in the same location.
length and position)
Auto mode 2 (Bypass
Used to scan a document stack with paper of
by length)
different sizes attached in different locations.
Irregular images may be output when multifeeds occur.
Modes can be selected from the operator panel or the Software
Operation Panel.
For information on how to configure the setting from the operator panel,
refer to
"4.2 Main Menu" (page
65).
For information on how to configure the setting from the Software
Operation Panel, refer to
"Specifying an Area Not to Detect Multifeed
[Intelligent Multifeed Function]" (page
Description
213).
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
114