Konica Minolta Fujitsu fi-6800 Operating Manual page 145

Chapter 8 Troubleshooting
Error Error message
code
J2:55 Multifeed detected (Overlap)
Press the iMFF button to
memorize the multifeed
pattern and eject document.
Press the Eject button to eject
the document.
When [Ready] is displayed,
increase the paper separation
force by using the [ ] button to
suppress multifeeds. (*1)
Multifeed detected (Overlap)
Press the iMFF button to
memorize the multifeed
pattern. Press the Eject button
to eject the document.
When [Ready] is displayed,
increase the paper separation
force by using the [ ] button to
suppress multifeeds. (*1)
J2:56 Multifeed detected (Length)
Press the Eject button to eject
the document.
J8:01 Sensor(s) dirty
Clean the Pick Sensor.
J8:02 Sensor(s) dirty
Clean the Skew Sensor.
J8:03 Sensor(s) dirty
Clean the FEED-TOP Sensor.
J8:04 Sensor(s) dirty
Clean the READ-TOP Sensor.
Countermeasure
When you press the [Eject]
button on the operator
panel, the multifed
documents are ejected.
Clean the sensor(s).
For details, refer to "Chapter
6 Daily Care" (page 118).
Error Error message
code
J8:05 Sensor(s) dirty
Clean the IMP-TOP Sensor.
J8:06 Sensor(s) dirty
Clean the EXIT Sensor.
J8:07 Sensor(s) dirty
Clean the JAM Sensor.
J9:61 Pick roller error
Pull down the Pick Roller Unit
to its correct position. Remove
excess documents from the
hopper.
J9:64 Brake roller/separator roller(s)
not installed correctly
Set the Brake Roller/
Separator Roller(s) unit
correctly.
*1: When the paper separation force is set to [
maximum level, the message "When [Ready] is displayed, increase the
paper separation force by using the [ ] button to suppress multifeeds."
does not appear.
Countermeasure
Introduction
Clean the sensor(s).
For more details, refer to
Scanner
"Chapter 6 Daily Care"
Overview
(page 118).
How to Load
Documents
Make sure that you do not
Configuring
have too many documents
the Scan
on the hopper and the pick
Settings
roller unit is not fixed in
upper position.
How to Use
the Operator
Check if the separator roller
Panel
or the brake roller is set
correctly.
Various Ways
For information on how to
check the rollers, refer to
to Scan
"7.3 Replacing the
Separator Roller" (page 134)
or "7.4 Replacing the Brake
Daily Care
Roller" (page 137).
] which is the
Replacing
Consumables
Troubleshooting
Operational
Settings
TOP
Contents
Index
Appendix
Glossary
145