Chapter 2 How to Load Documents
2
Adjust the hopper side guides to the document width.
Move the hopper side guides while pressing the side guide clutch so
that there is no space left between the documents and the hopper
side guides.
Otherwise, the documents may be scanned skewed.
Remove all paper clips and staples. Reduce the amount
of documents if a multifeed or pick error occurs.
Make sure that the hopper side guides do not pass the
line marks embedded on each side of the hopper.
Hopper
Line mark
Hopper Side
Guide
Side Guide
Clutch
Hopper Side Guide
Line mark
Make sure that the hopper side guides do not pass the
line marks embedded on each side of the hopper.
Good example
Hopper Side Guide
Line mark
Bad example
Hopper Side Guide
Line mark
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
36