Consumables And Replacement Cycles; Daily Care - Konica Minolta Fujitsu fi-6800 Operating Manual

Chapter 7 Replacing Consumables

7.1 Consumables and Replacement Cycles

The following table shows the consumables used for the
scanner.
Name Part No.
PICK ROLLER PA03575-K011
SEPARATOR ROLLER PA03575-
K012
BRAKE ROLLER PA03575-
K013
Consumables must be replaced periodically. It is
recommended that you keep a stock of new consumables and
replace them before it reaches the end of the consumable life.
Suggested replacement
cycle The scanner records the number of sheets scanned after
replacing the consumables (for pick roller, separator roller,
600,000 sheets or one year
brake roller), which allows you to check the status on each
consumable.
To check the status on the usage of the consumables, refer to
"9.3 Settings Related to Page Counters" (page
Note that the suggested replacement cycles are guidelines for
600,000 sheets or one year
using A4 (80 g/m
papers, as these cycles vary depending on the type of papers
scanned and how often the scanner is used and cleaned.
600,000 sheets or one year
To purchase the consumables, contact your FUJITSU scanner
dealer or an authorized FUJITSU scanner service provider.
Please note that some parts (other than the consumables)
need to be replaced by a service engineer, depending on the
type of documents scanned and how often the scanner is
used. For instance, Maintenance Parts (e.g. assist roller) need
to be replaced by a service engineer. For more information,
contact your FUJITSU scanner dealer or an authorized
FUJITSU scanner service provider.
2
[20 lb]) wood-free or wood containing
Only use the specified consumables.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring
the Scan
182). Settings
How to Use
the Operator
Panel
Various Ways
to Scan

Daily Care

Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
131