Table of Contents
Advertisement
Chapter 9 Operational Settings
Eliminating Shadows or Streaks on the Scanned
Image Edge [Page Edge Filler (Automatic Page
Size Detection)]
When scanning in Automatic Page Size Detection, depending
on the condition of the document that you scan, some shadow
of the document may be reflected onto the edge of the output
image and appear as black streaks.
In this case, you can improve the image quality around the
edges by using the Page Edge Filler function to fill around the
edges.
1
Start up the Software Operation Panel.
Refer to
"9.1 Starting Up the Software Operation Panel" (page
2
From the listing on the left, select [Device Setting 2]
[Page Edge Filler (Automatic Page Size Detection)].
3
Specify the width of each margin to fill; top, bottom, right,
and left.
T
Image
L
area
B
The specified area is filled in the same color as the background.
Note that if the target range of the Page Edge Filler is
170).
too wide, some characters near the edge may be cut
out.
For information on how to configure Automatic Page
Size Detection, refer to
Skewed Document Images" (page
Unless Automatic Page Size Detection is specified,
the setting of [Page Edge Filler (ADF)] is applied. For
more details, refer to
on the Scanned Image Edge [Page Edge Filler (ADF)]"
(page
This setting can also be configured from the scanner
driver's setup dialog box. Note that priority is given to
the setting with the larger value.
This setting does NOT appear when Kofax VRS is
used.
T :Top = 0 to 7.5 mm
B :Bottom = 0 to 7.5 mm
R :Right = 0 to 7.5 mm
L :Left = 0 to 7.5 mm
R
(in 0.5 mm increments)
"Automatically Correcting
97).
"Eliminating Shadows or Streaks
188).
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
189
Advertisement
Table of Contents
Troubleshooting
