Areas Not To Be Perforated; Loading Documents With Tabs Or - Konica Minolta Fujitsu fi-6800 Operating Manual

Chapter 2 How to Load Documents

Areas Not to be Perforated

An error may occur when there are punched holes in the area
shaded in light blue in the following picture.
Reference point
35
Front side
Center of document
The above condition applies when the document is set to the
center of the pick roller width.
If there are any holes in the 35 mm-wide central column, you
can move the document to the left or right to avoid an error.
Loading Documents with Tabs or Non-
rectangular Documents
To scan a document with tabs or a document that is non-
rectangular, place it in a way that does not get caught when it
is being fed through.
Leading edge
Good example:
Bad example:
Bottom of paper
(Unit : mm)
Example: Tab Example:
Non-rectangular document
*these parts may get caught
Example:
Example: Tab
Non-rectangular document
When you perform scanning as shown in the bad example
above, the indicated sections may be caught during
feeding. This may cause a paper jam or tear the document.
When a tab or the non-rectangular part of the document
does not pass above the feed roller/assist roller, these parts
of the document may remain in the generated image and
turn out elongated.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
43