Replacing The Brake Roller; Daily Care - Konica Minolta Fujitsu fi-6800 Operating Manual

Chapter 7 Replacing Consumables

7.4 Replacing the Brake Roller

1
Remove all documents from the stacker.
2
If the hopper has been raised, bring it back down to the
lower position.
For information on how to adjust the hopper level, refer to
the Loading Capacity of the Hopper" (page
3
Open the ADF.
For information on how to open the ADF, refer to
Closing the ADF" (page 20).
Be careful not to have your fingers caught
when the ADF closes.
4
Remove the brake roller from the scanner.
1 Open the roller cover. Lift up the cover from the lower middle.
"1.7 Setting
23).
"1.5 Opening/
5
Roller Cover
2 Remove the brake roller. Lift the left side of the roller first, then pull
out the shaft from left to right.
1
2
Install a new brake roller on the scanner.
1 Install the brake roller. Insert the shaft from the right side to the
left.
2
1
2 Close the roller cover. Make sure that both ends of the cover are
locked firmly.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring
the Scan
Settings
Brake Roller
How to Use
the Operator
Panel
Various Ways
to Scan

Daily Care

Replacing
Consumables
Troubleshooting
Brake Roller
Operational
Settings
Appendix
Glossary
137