Konica Minolta Fujitsu fi-6800 Operating Manual page 71

Chapter 4 How to Use the Operator Panel
6
Load the documents on the hopper, start up a scanning
application, and perform a scan.
For information about the scanning procedure in ScandAll PRO, refer
to "How to Use ScandAll PRO".
Depending on the number of sheets scanned, it will be displayed
as follows:
Sheets Display
75
sheets
100
sheets
110
sheets
Documents may not be counted correctly if a multifeed
occurs during scanning.
In the following cases, the scanning returns to normal
from Doc Count Check mode:
- When you only scan the specified pages (selecting
[Scan the specified number of pages] in [Scan
Settings] of ScandAll PRO)
- When you scan using a Job Separator
Description
Since the count has been set to
100 in step 4, it is -25 sheets.
[-] appears in the top right and
[Count] indicates "25".
If you load additional documents
at this point, you can scan up to
25 sheets.
Since the count has been set to
100 in step 4, it is +/- 0.
[=] appears in the top right and
[Count] indicates "0".
Since the count has been set to
100 in step 4, it is +10 sheets.
[+] appears in the top right and
[Count] indicates "0". Scanning
stops once 100 sheets have been
scanned.
When you press the [Counter Reset] button, the
screen returns to [Doc Count Check Mode] in step 5.
When you press the [Stop] button, it exits [Doc Count
Check Mode] and returns to the [Ready] screen.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
71