Konica Minolta Fujitsu fi-6800 Operating Manual page 172

Chapter 9 Operational Settings
Item Description
Page Counter Check the replacement cycle of
the consumables and the total
page count of the maintenance
parts.
Also use it to reset the counter
when you have replaced the
consumables or performed
cleaning.
Power saving Specify the waiting time before
entering power saving mode.
Offset Setting Adjust the position to start
scanning for the specified
scanning side(s).
Vertical Adjust the magnification level in
magnification feeding direction for the specified
Adjustment scanning method.
Setting/Value
Total Page Count(ADF) / After cleaning /
Brake Roller / Pick Roller / Separator
Roller / Assist Roller
Ink Level:Front / Ink Level:Back
(only when imprinter is installed)
Range: 5 min. to 235 min. (in increments of
5 min.)
SCSI or USB Connector 1:
ADF(Front) / ADF(Back)
SCSI or USB Connector 2:
ADF(Back)
Main/Sub: -2 to 3 mm
(in increments of 0.5 mm)
Applied to: ADF
Setting range: -3.1 to 3.1% (in increments
of 0.1%)
Factory Default SCSI or USB
Connector 1
: Configurable
0
Only displayed
when imprinter is
installed
15 min.
Main/Sub: 0 mm
0%
TOP
Contents
SCSI or USB
Index
Connector 2
Introduction
Scanner
Overview
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
172