Konica Minolta Fujitsu fi-6800 Operating Manual page 111

Chapter 5 Various Ways to Scan
7
Select an application to be launched by the [Send to] or
[Scan] button event and an operation to be performed.
Click [Start this program] under [Actions], and select an application
from the menu shown on the right.
8
Click the [OK] button.
For more details about ScandAll PRO, refer to "How to Use ScandAll
PRO".
If you are using an application other than ScandAll PRO, the setup of
the computer is completed here. Proceed to configure the scanner
settings.
The windows that appear and the operations differ by
the operating system that you are using.
To configure multiple buttons, repeat steps
To enable this setting in Windows 2000, click [OK] or
[Apply] for each button and restart the computer.
Scanner settings
Menu Function
/Enter
Send to Clear
Check
/Pause /Back
Stop
Scan
Counter
iMFF Reset Eject
[Scan] button
No particular setting is required.
The specified application starts when the [Scan] button is pressed.
[Send to/Pause] button
In the [Main Menu] of the operator panel, change the setting number
for the [Send to/Pause] button which is displayed on the LCD.
Match the number with the scanner button event configured in the
computer ([Send to 01] to [Send to 50]).
For instance, display "F02" in the LCD's indicator to execute an event
configured for [Send to 02].
The specified application starts when the [Send to/Pause] button
is pressed.
For more details about the operator panel, refer to
4 How to Use the Operator Panel" (page
For information on how to change the setting number for
[Send to/Pause] button, refer to
(page
5 to 8.
[Send to/Pause] Button
[Scan] Button
"4.3 Function Selection"
81).
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
"Chapter
Troubleshooting
60).
Operational
Settings
Appendix
Glossary
111