Konica Minolta Fujitsu fi-6800 Operating Manual page 31

Chapter 1 Scanner Overview
Connected via SCSI or USB Connector 2:
1
Turn on the scanner.
For information on how to turn on the power, refer to
Power ON/OFF" (page 17).
When connected via SCSI, turn on the scanner and
confirm that [Ready] is displayed on the LCD before
you turn on the computer.
When switching the connectors, make sure to power
off the scanner and the computer first.
2
Load documents on the hopper.
For information on how to load documents, refer to
Load Documents" (page 33).
3
Start up the application to use for scanning.
VCDemo will be used as an example here to explain the procedure.
"1.3 Turning the
For information on how to launch VCDemo, refer to the "Virtual
ReScan (VRS) User Guide". This manual is displayed when you open
"VRS User Guide.pdf" from the folder "\VRS\fi-6800\HVRS\
Documents" in the SETUP DISK DVD-ROM.
4
Select a scanner.
"Chapter 2 How to
When VCDemo is launched
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
31