Konica Minolta Fujitsu fi-6800 Operating Manual page 144

Chapter 8 Troubleshooting
Error Error message
code
J0:52 Paper jam
Remove the document and try
again.
J3:54 Skew detected
Remove the document and try
again.
Countermeasure
1 Remove the jammed
document(s). For
information on how to
remove documents, refer
to "8.1 Paper Jam" (page
140).
2 Check if the documents
are suitable for scanning
by ADF.
For more details, refer to
"2.2 Documents for
Scanning" (page 40).
3 Clean the rollers.
For more details, refer to
"Chapter 6 Daily Care"
(page 118).
1 Remove the jammed
document(s). For
information on how to
remove documents, refer
to "8.1 Paper Jam" (page
140).
2 Make sure that the hopper
side guides are not set
too wide.
Error Error message
code
J2:55 Multifeed detected (Overlap)
Press the iMFF button to eject
the document and to suppress
multifeed detection from next
scans. Press the Eject button
just to eject the document.
When [Ready] is displayed,
increase the paper separation
force by using the [ ] button to
suppress multifeeds. (*1)
Multifeed detected (Overlap)
Press the Eject button to eject
the document.
When [Ready] is displayed,
increase the paper separation
force by using the [ ] button to
suppress multifeeds. (*1)
Countermeasure
Introduction
When you press the [Eject]
button on the operator
Scanner
panel, the multifed
Overview
documents are ejected.
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
TOP
Contents
Index
Appendix
Glossary
144