Chapter 2 How to Load Documents
How to Load Documents
There are two ways to load the documents.
Setting the documents at the center of the hopper
This style is used mainly when the documents are of the same size.
Setting the documents by the left or right side of the
hopper
This style is used mainly when the documents are in different sizes or
when you want to shift the center of the documents.
Note that different conditions apply for multifeed detection
when you set the documents by either left or right side of the
hopper.
■Setting the documents at the center of the
hopper
1
Load documents on the hopper.
Set the documents with the front side (scanning side) facing up.
Make sure to keep the documents within the maximum
load line on the inside of the hopper side guides.
Pull out the hopper extension according to the length
of the document before placing the documents.
Maximum Load Line
Hopper Extension
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
35