Konica Minolta Fujitsu fi-6800 Operating Manual page 96

Chapter 5 Various Ways to Scan
5
Insert the document until the top edge touches the rollers
on the inside.
When more than one sheet is loaded, only insert the document on the
top of the stack.
The document is picked, scanned, then ejected onto the stacker.
After the scan, the scanner waits for the next sheet to be fed for
the time specified in the Software Operation Panel.
In [Continuous Feed] mode, the scanner separates the
documents and only scans one sheet at a time even when
multiple sheets are accidentally fed.
6
Repeat step
Roller
5 until all the documents are scanned.
Scanning can be stopped immediately by pressing the
[Counter Reset] button on the operator panel.
Scanning stops when no document is loaded on the
hopper after the time specified in the Software
Operation Panel.
The scanner waits for the period of manual feed
timeout even when there is no document left on the
hopper.
The timeout period for manual feeding can be
configured on the operator panel or in the Software
Operation Panel.
Continuous Feed mode can be cleared in [10: Hopper
Level] of the [Main Menu] on the operator panel. The
hopper is set to [4: Lower] when you clear manual
feeding (continuous). For more details about the
settings, refer to "4.2 Main Menu" (page
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring
the Scan
Settings
How to Use
65). the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
96