Attaching A Qos Policy Action To A Vlan; Session Manager Support For Qos; Feature History For Using Modular Qos Cli - Cisco Nexus 7000 Series Configuration Manual

Attaching a QoS Policy Action to a VLAN

Step 6
Attaching a QoS Policy Action to a VLAN
Procedure
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6

Session Manager Support for QoS

Beginning in Cisco NX-OS Release 4.2, Session Manger supports the configuration of QoS. This feature
allows you to verify the QoS configuration and confirm that the resources required by the configuration are
available prior to committing them to the running configuration. For information about Session Manager, see
the Cisco Nexus 7000 Series NX-OS System Management Configuration Guide, Release 6.x.
After you start the configuration session, do not enter any configuration commands using the configure terminal
configuration mode until the configuration session is aborted or committed. Entering parallel configurations
(one configuration that uses the configuration session and another using the configuration terminal configuration
mode) might cause verification failures in the configuration session mode.

Feature History for Using Modular QoS CLI

The table below summarizes the new and changed features for this document and shows the releases in which
each feature is supported. Your software release might not support all the features in this document. For the
Cisco Nexus 7000 Series NX-OS Quality of Service Configuration Guide
26
Command or Action
(Optional) switch(config)# copy
running-config startup-config
Command or Action
switch# configure terminal
switch(config)# vlan configuration vlan-id-list
switch(config-vlan-config)#service-policy
[type qos] {input | output} {policy-map-name}
[no-stats]
switch(config-if)# exit
(Optional) switch(config)# show policy-map
[interface interface | vlan vlan_id] [input |
output] [type qos | queuing] [class [type qos
| queuing] class-map-name]
(Optional) switch(config)# copy
running-config startup-config
Using Modular QoS CLI
Purpose
Saves the running configuration to the startup
configuration.
Purpose
Enters global configuration mode.
Enters VLAN configuration mode.
vlan-id-list is a space-separated list of VLANs.
Adds the policy map to the input or output
packets of a VLAN. Only one input policy and
one output policy can be attached to a VLAN.
Exits VLAN configuration mode and enters
global configuration mode.
Displays information about policy maps that
are applied to all interfaces or the specified
interface. You can limit what the device
displays to input or output policies, qos or
queuing polices, and to a specific class.
Saves the running configuration to the startup
configuration.