Installing The Device; Unpacking The Device; Installing The Cisco 5100 Encs; Rack-Mounting The Chassis - Cisco 5100 Series Hardware Installation Manual

Enterprise network compute system

Hide thumbs Also See for 5100 Series:

Table of Contents

Installing the Device

•

The device, accessory kit, publications, and any optional units may be shipped in more than one container.

When you unpack the containers, check the packing list to ensure that you have received all the items on the

list.

Only unpack the product when you are ready to install it. This will help prevent accidental damage.

If not already installed, the DIMMs and the M.2 storage module must be installed before rack-mounting or

wall-mounting the chassis.

Warning

Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement

1030

The Cisco 5100 ENCS can be installed in 19-inch (48.26-cm) racks. Use the standard brackets shipped with

the chassis for mounting the chassis in a 19-inch EIA rack.

Warning

To prevent airflow restriction, allow clearance around the ventilation openings to be at least: 1-inch (25.4-mm)

Statement 1076

You can mount the device in the following ways:

Unpacking the Device, on page 15

Installing the Cisco 5100 ENCS, on page 15

Grounding the Chassis, on page 18

Powering On the Server, on page 19

Initial Server Setup, on page 19

Cisco 5100 Enterprise Network Compute System Hardware Installation Guide

C H A P T E R

Table of Contents