Configuring Command-Line Access To The Router - Cisco 1700 Quick Start Manual

Configuring Dynamic Routing Parameters
Step Task
5 Configure this interface for PPP encapsulation.
Enable this interface and the configuration changes you have just
6
made on the interface.
Exit configuration mode for this interface.
7
Configuring Dynamic Routing Parameters
Use this table to configure some dynamic routing parameters.
Step Task
1 Enable RIP routing on the router and enter router
configuration mode.
Specify the router to use RIP version 2.
2
Enable Enhanced IGRP for this network.
3
4 Disable automatic summarization of subnet routes into
network-level routes.
Configure the router to forward packets addressed to a subnet
5
of a network with no network default route.
6 Exit router configuration mode.
Configuring Command-Line Access to the Router
Use this table to configure some parameters that control access to the router.
Step Task
Specify the console terminal line and enter line configuration mode.
1
Set the interval that the EXEC command interpreter waits until user input
2
is detected.
Specify a virtual terminal for remote console access
3
4 Specify a password on the line.
Enable password checking at terminal session login.
5
6 Exit configuration mode.
Verifying Your Configuration
You can verify your configuration by checking the serial interface configuration:
Step 1
Step 2
4-4 Cisco 1700 Router Software Configuration Guide
From privileged EXEC command mode, enter the show interface serial 0 command.
Confirm that the "Serial0 is up, line protocol is up" message (shown in bold in the
example) appears in the command output.
1700# show interface ser0
Serial0 is up, line protocol is up
Hardware is PowerQUICC Serial
Router Prompt
1700(config-if)#
1700(config-if)#
1700(config-if)#
Router Prompt
1700(config)#
1700(config-router)#
1700(config-router)#
1700(config-router)#
1700(config-router)#
1700(config-router)#
Router Prompt
1700(config)#
1700(config-line)#
1700(config-line)#
1700(config-line)#
1700(config-line)#
1700(config-line)#
Command
encapsulation PPP
no shutdown
exit
Command
router rip
version 2
network 10.0.0.0
no auto-summary
ip classless
exit
Command
line console 0
exec-timeout 5
line vty 0 4
password <lineaccess>
login
end