Xerox 721 Message Manual page 92

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-16
OS1175 Command not allowed while **** is active
The command entered cannot be processed while the indicated
task is in progress.
Action 1. Exit indicated task. (Refer to appropriate section of your
4635 LPS Operations Reference for instructions.)
2. Reenter the command.
OS1180 Invalid response
Response to a prompt was incorrectly entered.
Action Reenter response, ensuring accuracy and the correct number of
characters.
OS1190 Invalid parameter, command ignored.
An undefined bin is specified or the sheet count for the bin is
not within the allowable range.
Action Verify the bin and reenter the command
or
Change the BLIMIT command to allow your number of sheets.
(The allowable range is 100-2500 sheets.)
or
An undefined tray is specified in the command. Verify the tray
number and reenter the command. (The allowable trays are 1-6.)
OS1195 Undefined ink: color
The ink you specified (represented by the word color in the
message shown) is incorrect.
Action 1. Check to make sure that the ink name is entered correctly.
2. If the message reappears, consult your systems specialist.
OS1200 Command not allowed while HIP or SDI active
The system is unable to respond to the entered command while
the printer is in communication with the host interface processor.
Action 1. Terminate connection with HIP. (Refer to the HIP chapter in
your 4635 LPS Operator Guide.)
2. Reenter the desired command.
OS1215 Input stopped after orderly shutdown
A software failure has caused a system rollover. Data being input
has stopped processing while the system attempts to reestablish
the correct state at the time of failure in an effort to recover all
data.
Action Follow directions appearing at the system controller display to
initiate automatic job recovery and abort the analysis dump.
(Refer to the offline chapter in your 4635 LPS Operator Guide.)
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE