Xerox 721 Message Manual page 60

IFU (INTERPRESS FONT UTILITY) MESSAGES
5-22
IF2960 JSL parse err x - unexpected token type (y, z)
A character or symbol is included in the JSL file that the system
cannot read.
Action 1. Correct the JSL file, omitting any incorrect elements.
2. Retry the command.
IF2970 Invalid hardvalues parameter.
An invalid value was assigned to the HARDVALUES parameter in
the font profile.
Action 1. Change the HARDVALUES parameter in the font profile to
YES or NO.
2. Reenter the ADD command.
IF2971 Bad CHARS parameter
The CHARS parameter in the font profile contains invalid syntax.
Action 1. Correct the syntax of the CHARS parameter.
2. Reenter the ADD command.
IF2972 Bad COMPOSITES parameter.
The COMPOSITES parameter in the font profile contains
incorrect syntax.
Action 1. Correct the syntax of the COMPOSITES parameter in the font
profile.
2. Reenter the ADD command.
IF2973 No valid characters were found in character set x
In processing the FIS master, the substitute character's raster
bitmap is either missing or defective.
Action 1. Correct the CHARS parameter of the font profile.
2. Reenter the ADD command.
IF2974 Character x is in the system reserved area
No characters may be added in the range 0-20
These positions are reserved for system use.
Action 1. Remove the invalid characters from the CHARS parameter in
the font profile.
2. Reenter the ADD command.
IF2975 Contour fonts require RIP option; aborting ADD
The FIS master contains contour character shapes which require
the RIP option.
Action None.
8
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE
or 0-20 (octal).