Xerox 721 Message Manual page 49

XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE
IF2241 FISname not in font profile, using name from FIS master.
The FIS-name parameter in the font profile was omitted. The
name from the FIS master will be used to create the font.
Action None.
IF2245 Font or character size exceeds standard format.
The font file bitmap size exceeds 1 Megabit or one or more
characters exceed 1024 bits high by 512 bits wide (if viewed in
portrait orientation).
Action If your system can utilize the 5-word FST format (with version 3
software), set the FTYPE parameter in the font profile to
FTYPE = EXTENDED and retry the ADD process.
or
If your system does not have the 5-word FST format, decrease
the number of characters requested in the CHARS/DCCHARS
parameter in the font profile and retry the ADD process.
IF2250 Medium must be tape or cartridge.
Magnetic tape or cartridge are the only media possible for the
ADD command (some commands do not accept floppy disks).
Action Reenter the command specifying either magnetic tape or
cartridge.
IF2304 Font profile name is required in ADD command
The ADD command must contain the desired font profile name.
Action Reenter the ADD command, to include the applicable font profile
name.
IF2306 Font profile x cannot be opened
The requested font profile cannot be opened.
Action 1. Verify that the font profile exists on the system and that it is
not corrupted.
2. Reenter the ADD command.
IF2318 Nonnumeric resolution parameter
The resolution of the font must appear numerically as 300 or 600
(spi) in the IPFONTS or DCFONTS statement of the font profile.
Action 1. Correct the IPFONTS or DCFONTS statement using "300" or
"600" as the resolution parameter in the font profile.
2. Reenter the ADD command.
IF2324 Pt size x and orient y were not requested; skipping ADD
The expected point size and orientation have not been
requested, and the ADD command will not be processed.
Action None.
IFU (INTERPRESS FONT UTILITY) MESSAGES
5-11