Xerox 721 Message Manual page 134

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-58
OS2700 Key-in lost. Reenter.
The system was unable to process the command when entered
because another ongoing process temporarily conflicted with it.
Action Wait a few seconds and reenter desired command.
OS2705 Recovery in progress... keyin not allowed.
Recovery is currently in progress. The attempted operation was
ignored.
Action Wait for recovery to complete, following any additional
instructions.
OS2710 Invalid command reenter.
A command was entered that the system does not recognize, or
a command was improperly keyed in.
Action 1. Reenter the command correctly.
2. If the message reappears, the command cannot be used with
your system.
OS2711 CMD not allowed while diagnostic print job is in progress.
You have entered a command that cannot be processed because
a diagnostic print job is being run.
Action None.
OS2712 Command not allowed while task is running.
The command entered cannot be processed while the current
task is ongoing.
Action 1. Abort the current task or wait until it is completed.
2. Reenter the desired command.
OS2713 This command is no longer supported. See -11
The command entered is obsolete; your system cannot respond.
Action 1. Refer to your 4635 LPS OSS Program Description ("-11") for
the correct command for the desired process.
2. If information cannot be located, contact your systems
specialist or Xerox Customer Support.
OS2714 Unable to obtain status at this time. Retry
The PRNTRSTATUS or JOBS command cannot be honored at this
time. The PRNTRSTATUS command will not be honored while
output is establishing communications. The JOBS command may
not be honored if either input or output is performing a report
transition or is near the end of the job.
Action Retry.
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE