Xerox 721 Message Manual page 267

4635 LPS ADDITIONAL MESSAGES
15-24
Bad block on tape device.
The tape drive is unable to read a specific block of datafrom the
tape. This could be caused by damaged media or a dirty or
defective tape drive.
Action 1. Clean the tape drive.
2. Replace the tape.
If the problem occurs when no audit logs are being displayed or
printed call Xerox Customer Service.
BTEXT date parameter exceeds 365 days.
The number of days specified in the BTEXT LDT parameter is too
large.
Action Check JSL or DJDE in job stream to ensure that all BTEXT LDT
keywords and parameters are correct.
BTEXT signal unrecognized; not PAG or RPT
A BTEXT keyword or parameter is invalid.
Action Check JSL or DJDE in job stream to ensure that all BTEXT
keywords and parameters are correct. This error occurs when
data in the DJDE BTEXT is completely unrecognizable
BTEXT signal Page Detail text invalid
BTEXT Page Detail text is incorrect.
Action Check JSL or DJDE in job stream to ensure that all Page Detail
BTEXT keywords and parameters are correct. parameters to
check are SEQ, PRA, and TXT. If the problem persist, call Xerox
Customer Service
BTEXT signal text invalid
A BTEXT keyword or parameter is invalid.
Action Check JSL or DJDE in job stream to ensure that all BTEXT
keywords and parameters are correct.
BTEXT signal text invalid response
A BTEXT keyword parameter contains invalid data, for example an
incorrectly specified date.
Action Check JSL or DJDE in job stream to ensure that all BTEXT
keywords and parameters are correct.
BTEXT signal text truncated
A BTEXT signal has exceeded the maximum buffer size allowed,
resulting in truncation of the excess data. This may be caused by
keyword parameters that exceed the published maximum sizes.
Action Check JSL or DJDE in job stream to ensure that all BTEXT
keywords and parameters are correct.
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE