Xerox 721 Message Manual page 29

XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE
HP1270 Change of job nn to file xxxxxx completed successfully
The CHANGE command successfully created the file.
Action None.
HP1280 HIP reset not allowed. Invalid task state
HIP is online and/or jobs in the HIP queue are not completed.
HIP must be offline and all jobs must be completed before the
HIP RESET command can be invoked (these restrictions do not
apply at logon level 4).
HP1290 Host suspended pending pass-through job initiation
A pass-through job was received and the HIP online interface was
suspended.
Action None.
HP1291 HIP resuming following pass-through job
The pass-through job has completed and HIP is ready to receive
data
Action None.
HP1298 XPS communications recovered
HIP can now receive data via the XPS communication mode.
Data received but not yet written to system disk will be copied
from memory (saved at system error restart) and written to
system disk. The system then reestablishes the communications
link and continues to receive the next block of data.
Action None.
HP1299 XPAF communications recovered
HIP can now receive data via the XPAF communication mode.
Data received but not yet written to system disk will be copied
from memory (saved at system error restart) and written to
system disk. The system then reestablishes the communications
link and continues to receive the next block of data.
Action None.
HP1300 Assuming negative confirmation
A confirmation prompt requiring a YES or NO response was
displayed. No response was entered within the system's time
limit. The system is responding as if N were entered.
Action If the Y response was intended, reenter the command,
responding to the confirmation prompt within the system time
frame of 30 seconds.
HIP (HOST INTERFACE PROCESSOR) MESSAGES
4-7