Xerox 721 Message Manual page 185

XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE
OS9200 Hardware error-input drive. Call for service.
A fatal error other than a read error has occurred. Due to the
failure mode, the data block in question cannot be recovered.
Action 1. If data loss is acceptable, press the <CON> key to resume
printing.
or
If loss is unacceptable, enter the ABORT job command to cancel
the job.
2. Restart the job.
3. If the problem continues, contact your systems specialist or
Xerox Customer Service and report SAN (Software Analysis
Number) 20.00.02.
OS9210 Parity error on input medium.
A parity error has been discovered in the magnetic tape input
buffer in CPU memory. (The error was not reported by the
magnetic tape drive itself.)
or
The message also appears if attempting to read a 6250 bpi tape
on a 1600 bpi magnetic tape drive.
Action 1. Clean the magnetic tape drive. (Refer to the maintenance
chapter in your 4635 LPS Operator Guide.)
2. Check the tape density.
3. Restart the job and/or mount a tape of correct density for the
tape drive.
4. If the problem continues, contact your systems specialist or
Xerox Customer Service.
OS9300 Page set-up error. Page won't be printed. ABORT O or
The page cannot be printed because a dispatching error has
occurred three consecutive times. This may be due to data
exceeding the capability of the character dispatcher. (Message is
followed by message OS2000.)
The printer control console displays:
OUTPUT STOPPED. SEE MESSAGE AT CRT.
Action 1. Enter the CONTINUE O command. The job will print with
one page missing.
or
Enter the ABORT O command to cancel the report.
2. Recreate the job, reducing the amount of data per page.
Note: CRT refers to the 4635 LPS system controller display.
OS9305 Duplex set-up error. Page won't be printed. ABORT O or
The page cannot be printed because the front side of a page
printed on both sides (duplex) contains more data than can be
retrieved and set up by the system. (This message is followed by
message OS2000.)
Action 1. Enter the CONTINUE O command for the job to print with
one page missing.
or
Enter the ABORT O command to cancel the report.
2. Recreate the job, reducing the amount of data per page.
OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-109