Xerox 721 Message Manual page 182

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-106
OS8950 Insufficient dynamic memory to run requested task.
Not enough dynamic memory remains to load the requested
task. Memory has been reported as inoperable during the
system boot, or the system disk file of the desired task has been
modified.
Action 1. Reboot the system by pressing the Boot button and entering
B.
2. Restart the job.
3. If the problem continues, resysgen if authorized to do so
(refer to your 4635 LPS System Generation Guide),
or
Contact your systems specialist.
OS8960 File management initialization failure - Reboot.
The system's attempt to initialize file management processing has
failed.
Action Reboot the system.
OS8970 Cannot open recovery file.
The automatic job recovery file which contains data necessary to
recover after a system rollover has been left in a state such that it
cannot be accessed.
Action Resysgen the disk to recreate the file (refer to your 4635 LPS
System Generation Guide),
or
Contact your systems specialist.
OS8980 Unable to initiate input task.
The requested input task cannot be found or read from disk.
Action 1. Enter the RESET command.
2. Restart the job.
3. If the message reappears, reboot the system by pressing the
Boot button and entering B.
4. Restart the job.
5. If the problem continues, resysgen, if authorized to do so
(refer to your 4635 LPS System Generation Guide),
or
Contact your systems specialist.
OS8985 Unable to initiate HIP task.
The HIP task cannot be started.
Action 1. Wait until the system is idle, then retry.
2. If problem persists, reload system software.
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE