Xerox 721 Message Manual page 35

XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE
HP2346 Command not allowed on system UI.
This message is in response to a service-oriented command
which creates a display that the system PC-UI is not capable of
handling.
Action Use a LINK terminal to execute this command.
HP2400 HIP interface must be offline. Enter 'HIP OFF'
The HIP DIAGNOSTIC command was entered. HIP must be
offline to perform diagnostics.
Action 1. Enter the HIP OFFLINE command.
2. Reenter HIP DIAGNOSTIC.
HP2410 Abort current transmission; confirm with 'Y'
This message is a confirmation prompt appearing after the HIP
ABORT command was entered.
Action Enter Y to abort the job
or
Enter N if abort is not desired.
HP2420 Defer hip diagnostic until OCS queue idle
The HIP DIAGNOSTIC command was entered while a job was
queued or being processed. The command is being ignored.
Action Wait until all jobs print.
or
Enter the ABORT job command to cancel the job (if only one
remains).
or
1. Enter the RESET command to delete all jobs.
2. Reenter the HIP DIAGNOSTIC command to proceed with
diagnostics.
HP2500 Change of job xxxx to file file-type failed: unrecoverable I/O
error yy.
The CHANGE command failed due to the error values specified
in this message. These error values will be one of the following:
• 03 disk controller failed
• 04 disk parity errors
• 10 end of file detected
• 24 device full (insufficient space for the file)
• 26 no such file
• 32 input file read error
• 56 output file write error
• 59 disk device fault (unable to perform operation).
All of the values listed above except 24 will generate an error log
entry.
Action If value 24 is received, your company's analyst/programmer
should free up sufficient contiguous system disk space by either
deleting unnecessary files or compressing the disk.
Note: Compressing the disk where the HIPBF.SYS resides should
not be performed because the HIP files will become inaccessible.
HIP (HOST INTERFACE PROCESSOR) MESSAGES
4-13