Xerox 721 Message Manual page 148

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-72
OS4050 Forms/Fonts/Graphics values are too large. Enter new values
via the Forms/Fonts/Graphics command
The command FORMS n, FONTS n, or GRAPHICS n was entered
with an n value greater than the system permits per job.
(Maximum allowable: fonts—128; forms—64; graphics—128.)
Action Reenter the command with a value within the acceptable range.
(Refer to your 4635 LPS Operations Reference chapters on using
the font editor and using graphics, or the 4635 LPS Forms
Creation Guide.)
OS4100 Printer is in diagnostic mode. Call for service.
The printer is in a standalone diagnostic mode and cannot
process any communication.
Action Contact your systems specialist or Xerox Customer Service.
OS4150 Input drive is offline. 'CONTINUE I' when it is ready.
The START or MOVE command was entered while the tape drive
was not online to the printer.
Action 1. Press the On Line button on the tape drive.
2. Enter the CONTINUE I command to resume input.
OS4200 Input drive not responding, do one of the following: *Verify
drive is online, 'CONTINUE I' when ready* call for service
Software is issuing input/output commands, but the tape drive is
not responding with status information.
Action 1. Press the On Line button if the tape drive is offline to the
printer.
2. Enter the CONTINUE I command.
3. If the message is still displayed, contact your systems
specialist or Xerox Customer Service.
OS4201 Unable to complete operation. Check drive.
A hardware problem exists with the tape drive. The system is
unable to complete the operation in progress.
Action Contact your systems specialist or the Xerox Customer Service.
OS4310 Irrecoverable tape read error during tape dump.
The START n, DUMP command was entered, but software is
unable to read tape.
Action 1. Clean the magnetic tape drive. (Refer to the maintenance
chapter in your 4635 LPS Operator Guide.)
2. Reenter the command.
3. If the message reappears, contact your systems specialist or
Xerox Customer Service.
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE