Xerox 721 Message Manual page 235

XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE
Define CLUsters and load papers as follows:
Stock requests in the document are handled by defining
temporary cluster names. This message is displayed on the
system controller display and is followed by instructions for
loading paper and defining clusters.
Action 1. If printing stops and you are prompted to key in the
CONTINUE command, load the correct stock in the feeder
trays.
2. Define the clusters as instructed.
3. Key in the CONTINUE command or press the
<CONTINUE> key.
Document generated comment (page n) = "commentString."
The document requested that a comment be added to the
summary sheet.
Document Generated Comment "documentComment".
A comment field is taken from the printing instructions or
protocol and is displayed on the summary sheet.
Document printing terminated due to error(s).
The job was ended because of a previous error on the summary
sheet. This message is added to the actual error message.
Error sheet only; document not printed due to errors.
This message is added to the actual error message if no data had
been formatted for printing when the job was aborted due to
errors.
(mapped from character nB, set nB).
When character mapping occurred for a particular character, that
character did not exist at the new location. The message
...character not in font... is also issued.
Note: In this message, the letter "B" indicates an octal value.
No font for output character set 0B, can not substitute blanks.
No font for output character set 0B, can not substitute
blanks.
Character substitution failed because no substitute character was
defined for this Interpress family. This happens when LPS fonts
are not created through the FIS utility, or if no substitute
character is specified in the FIS master. This message follows the
... Font Problem ... message.
Note: In this message, the letter "B" indicates an octal value.
SUMMARY SHEET ERROR MESSAGES
14-11