Xerox 721 Message Manual page 276

XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE
FCG Exiting: Invalid Profile—Output or input not specified
The profile requires OUT135 prior to parameter 1 to determine if
these values are to be used for an output profile. if OUT135 has
not been included in the specified profile, the following message
is displayed:
FCG Exiting: Invalid profile—too many parameters.
You have exceeded the acceptable number of parameters
allowed in the profile.
FCG Exiting: Invalid profile—not enough parameters.
You have specified too few parameters in the profile.
FCG Exiting: PVNUM.SYS not present on system
Necessary information for the FCG SHOW command is not in the
system.
FCG Exiting: Profile for %0 successfully loaded
The profile you have requested has been found and its
parameters have been loaded.
FCG Starting: Version: %0
You have entered a correct profile label. The appropriate version
number is also displayed.
File cannot be accessed . . . .
The file is too large for the PC Editor to process.
Action If the file is an ESS file, use EDI in the message window.
File could not be emptied or deleted. Ensure that the
filename is valid.
An incorrect file name may have been entered, or the file name
does not exist.
Action 1. Check the file listing of the window you are working in for
the correct file name.
2. If the problem persists, contact your systems specialist.
File could not be found. Ensure that the file name is valid.
An incorrect file name may have been entered, or the file name
does not exist.
Action 1. Check the file listing of the window you are working in for
the correct file name.
2. If the problem persists, contact your systems specialist.
3. Call Xerox Customer Service.
4635 LPS ADDITIONAL MESSAGES
15-33