Xerox 721 Message Manual page 74

IFU (INTERPRESS FONT UTILITY) MESSAGES
5-36
IF8500 Decomposed FIS file has bad syntax.
An error occurred while the system was processing an internal
temporary file.
Action 1. Reenter the ADD command.
2. If the problem continues, contact your systems specialist or
Xerox Customer Support.
IF8501 Fatal error has been detected in font request
An error occurred while the system was processing the font
request.
Action 1. Reenter the ADD command.
2. If the problem continues, contact your systems specialist or
Xerox Customer Support.
IF8502 Character x returned error code y.
A character in the decomposed FIS caused an error code to
appear.
Action 1. Reenter the ADD command.
2. If the problem continues, contact your systems specialist or
Xerox Customer Support.
IF9000 **- DEVICE IS NOT READY -**
The medium specified was not available when the operation was
attempted, or during the operation.
Action 1. Prepare the medium for operation and retry the command.
2. If the retry fails, replace the media and retry.
IF9001 **- END OF FILE HAS BEEN DETECTED -**
An end of file (tape mark) has been encountered.
Action None.
IF9002 **- END OF VOLUME HAS BEEN DETECTED -**
The logical end of volume was detected during the task
execution. The tape is left positioned between the two tape
marks. (This condition is not detected during the read
operations.)
Action Reposition the medium to the beginning of where the WRITE
operation should start and retry the operation.
IF9003 **- DEVICE IS FULL (FCP) -**
This message indicates an attempt to write to a medium that is
full.
Action None.
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE