Agilent Technologies InfinityLab LC Series User Manual page 60

3 Using the Pump
Setting up the Pump with the Instrument Control Interface
Instrument Signals
The following pump signals are displayed:
Table 9
Flow
Pressure
Ripple
Pressure Limit
Table 10
Flow
Pressure
Ripple
Pressure Limit
Composition A:B
Composition C:D
Context Menu
The context menu of the dashboard panel contains the following commands:
Agilent InfinityLab LC Series 1260 Infinity II Isocratic and Quaternary Pumps User Manual
Pump signals (isocratic pump)
The current solvent flow rate (in mL/min).
The current pump pressure (in bar, psi or MPa, see
Configuration"
The current ripple (in %).
The current maximum pressure limit.
Pump signals (quaternary pump)
The current solvent flow rate (in mL/min).
The current pump pressure (in bar, psi or MPa, see
Configuration"
The current ripple (in %).
The current maximum pressure limit.
The contributions of channels A and B to the current solvent composition.
The contributions of channels C and D to the current solvent composition.
Control Displays the pump's Control dialog box.
Method Displays the pump's Method Setup dialog box.
Set Error Method Sets the method that is loaded if an error occurs to the method that is
currently available in the hardware.
Identify Device Causes the LED on the front of the module to blink for a few seconds.
Switch Pump On/Off Toggles the status of the pump, on or off.
Bottle Fillings Displays the Bottle Fillings dialog box.
on page 57).
on page 57).
"Instrument
"Instrument
60