12
LAN Configuration
Dynamic Host Configuration Protocol (DHCP)
2 Set the configuration switch to DHCP either on the G1369C LAN Interface
Table 28
SW 4
ON
Table 29
SW 6
ON
3 Turn on the module that hosts the LAN interface.
4 Configure your Control Software (e.g. OpenLAB CDS ChemStation Edition, Lab
Agilent InfinityLab LC Series 1260 Infinity II Isocratic and Quaternary Pumps User Manual
Card or the mainboard of above mentioned modules.
G1369C LAN Interface Card (configuration switch on the card)
SW 5
SW 6
OFF
OFF
LC Modules with 8-bit configuration switch (B-firmware) (configuration switch at rear
of the instrument)
SW 7
SW 8
OFF
OFF
Advisor, Firmware Update Tool) and use MAC address as host name, e.g.
0030d3177321.
The LC system should become visible in the control software (see Note in
section
"General Information (DHCP)"
SW 7
SW 8
Initialization Mode
OFF
OFF
DHCP
Initialization Mode
DHCP
on page 224).
226