Touch Panel Display; Radio - Agilent Technologies Helium User Manual

Instructions for Use
The performance and operating safety of this equipment can only be guaranteed
CAUTION
if it is operated according to normal conditions of use.
Allow at least 2 to 3 feet of clearance adjacent to the slots at the front, sides and
back of the equipment enclosure.
Allow sufficient room for the operator to safely maneuver to perform testing.

Touch Panel Display

Do not apply excessive pressure to the Touch Panel display as this may cause
CAUTION
smears.
In general, the lower the temperature, the longer it takes the Touch Panel display
to turn on. Performance of the Touch Panel display may deteriorate in low
temperature.

Radio

The Wireless Remote Control and Base Board PCB are built around Laird's, model
RM024, RF transceiver module operating in 2.4 GHz ISM band. The same type of
the RF module is built in an Agilent Technologies Helium Mass Spectrometer Leak
Detector Wireless Base Station PCB and Wireless Remote unit (see Agilent
Technologies Helium Mass Spectrometer Leak Detector Wireless Remote
Operational Manual (6999099945A).
Agency Identification Numbers for Laird, Model: RM024 AC4424-100:
US/FCC ID: KQL-RM024

CAN/IC: RSS-210

EUR/ETSI EN: CE

Taiwan: CCAI13LP3400T1, CCAI13LP3330T3

are also applied to the Agilent's Wireless Remote and Agilent Technologies Helium
Mass Spectrometer Leak Detector Wireless Base Station, when the units are used
the approved antennas.
18 Agilent Helium Leak Detector User Manual