Agilent Technologies Helium User Manual page 21

Instructions for Use
CAN/CSA-C22.2 No. 61010-1-12 - Safety Requirements for Electrical
WARNING
Equipment for Measurement, Control, and Laboratory Use - Part 1: General
Requirements.
UL Std. No. 61010-1, 3rd Edition - Safety Requirements for Electrical
Equipment for Measurement, Control, and Laboratory Use - Part 1: General
Requirements.
EMC Emissions and Immunity - ETSI EN 301 489-1 v2.2.0 (2017-03)
Electromagnetic Compatibility and Radio Spectrum Matters (ERM);
Electromagnetic Comparability (EMC) standard for radio equipment and
services; Part1: Common technical requirements.
• Any modifications on the part of the user are liable to cause non-compliance
with regulations or affect the EMC performance and the safety of the product.
Agilent cannot be held responsible for consequences resulting from such
intervention.
• Before powering the unit the first time, verify that the unit is configured to
operate for the local mains supply voltage.
• The equipment can be damaged by:
 Incorrect mains AC supply voltages
 Radio Frequency (RF) and Electrostatic Discharge (ESD) energy inputs
 Operating in very high temperatures or without adequate ventilation
 Immersion in liquids
 Physical abuse
• All electrical connections must be performed by a qualified electrician and
must comply with national and local codes.
• Opening the enclosure may expose hazardous voltages. Always disconnect
the power cord and interface cables before opening the enclosure. Do not
touch the power inlet's contacts for at least 10 seconds after disconnecting
the power cord.
• Electrical installation must include the appropriate branch circuit (20 A
maximum), with a long time delay and a reliable earth ground.
• Use only the power cord that was provided with your leak detector. The use of
extension cords is not recommended and could result in damage to the
equipment and loss of warranty.
• To avoid electric shock, connect the product power cord to a grounded power
receptacle. A power cord with a grounding conductor is required.
• Allow an adequate distance (2 to 3') from the back of the leak detector to the
power source. This ensures easy access to the power cord for connecting or
disconnecting purposes.
Agilent Helium Leak Detector User Manual
that exceed the maximum ratings
21