Agilent Technologies Helium User Manual page 140

Technical Information
Table 15 Current Setup Screen Conditions
Condition
Audio Set Point
See Section
"Current Setup Menu".
Auto Sequencer
See Section
"Current Setup Menu".
Calibration Set-Up
See Section
"Calibration Screen".
Leak Rate Range
See Section
"Calibration Screen"
Range Stop
See Section
"Calibration Screen"
Reject Set Point
See Section
"Current Setup Menu".
Split Flow
See Section
"Split Flow".
Vent Lockout Status
See Section
"Menus Screen".
140
Display
Audio Set Point: Active
Audio Set Point: Inactive Audio Set Point is inactive.
Auto Sequencer: On
Auto Sequencer: Off
Int Cal Leak
Ext Cal Leak
Auto Ranging
Manual Ranging
Range Stop -[Exp]
Reject# 1,2,3,4 Active
Agilent Helium Leak Detector User Manual
Description
Audio Set Point is active.
Auto Sequencer (automatic test cycle)
is enabled.
Auto Sequencer (automatic test cycle)
is disabled.
System is set to calibrate to the
internal standard leak.
System is set up to calibrate to an
external standard leak.
System is set to auto range through
the leak rate scale.
System is set for manual range
control.
System is set to display the most
sensitive leak rate range, 10-
The range stop line shows only if
range stop is on.
Reject set points displayed are active;
this line is blank when all set points are
disabled or inactive.
Shows split flow, only if the feature is
turned on. To change the status, go to
the Advanced Parameters screen.
Shows the status of the vent lockout
feature only if it is on. To change the
status of the vent lockout feature, go
to the Control Panel access screen.
[Exp]
.