Table of Contents
Advertisement
Instructions for Use
Undo Shipping Locks
A leak detector with either an IDP-15 pump or a TS620 pump is shipped with
shipping lock bolts to secure the pump during transit. Remove these shipping locks
before powering on the leak detector to prevent excessive rattle and noise during
operation (see following figure).
Figure 4 Shipping Locks
1
Use a flat tip screwdriver to remove the side walls from the leak detector cart.
Remove the panels and set aside.
2
For the:
Figure 5 IDP-15 Rear Pump Access
28
IDP-15 model, also remove the rear panel of the cart, opposite of the handle
to access the rear of the pump, opposite the pump cooling fan. If any,
remove and file paperwork attached to the pump.
Agilent Helium Leak Detector User Manual
Advertisement
Table of Contents
