Omron M1 Series User Manual page 610

7 Other Functions
Parameter
No.
E01 to E05,
E98, E99
Output frequency
ROK input
RUN command
FW/RV input
7-9-8 Frequency Calculation Function
When "13: Calculation result" is set to Frequency Reference Selection (F01/C30), two frequency refer-
ences are calculated.
Parameter
No.
F01/C30
E131
E132
E133
Note 1. The same setting can be made in E131/E132.
Note 2. If the calculation results exceed 1st Maximum Output Frequency (F03)/2nd Maximum Output Frequency
(A01), the limit is set at the maximum frequency. Similarly, if the calculation results are below 0.0 Hz, the
limit is set at 0.0 Hz.
7-9-9
Frequency Addition Function
Use this function to add or subtract the value set at Frequency Addition Amount (E134) to or from the
selected frequency reference.
If "161: ADD" is not allocated to the multifunction input terminal, or if the ADD terminal is ON, add or
subtract E134. If the ADD terminal is turned OFF, the addition or subtraction of Frequency Addition
Amount (E134) is canceled, and the inverter returns to the status of the selected frequency reference.
7-118
Function name
Input Terminal [DI1] to [DI7]
Function Selection
Function name
1st Frequency Reference
Selection/2nd Frequency
Reference Selection
Frequency Calculation Oper-
ation Target 1
Frequency Calculation Oper-
ation Target 2
Frequency Calculation Oper-
ator Selection
Data
38: ROK (Permission of Run com-
mand)
Data
13: Calculation result
0: or keys on Operator
1: Voltage input to terminal [AI1] (0 to
10 VDC)
2: Current input to terminal [AI2](AII)
(4(0) to 20 mA DC)
3: Voltage input to terminal [AI2](AIV)
(0 to 10 VDC)
5: Pulse train input
6: RS-485 (terminal block)
7: Do not set
0: Addition (E131 + E132)
1: Subtraction (E131 - E132)
2: Multiplication (E131 x E132)
M1 Series Standard Type User's Manual (I669)
Default data Unit
- -
Default data Unit
0 -
1
-
2
0 -