Omron M1 Series User Manual page 413

Set the following constants according to the settings of 1st Drive Control Selection (F42)/2nd Drive
Control Selection (A14).
Dynamic Torque Vector Control (With/without Speed Sensor) (In-
duction Motor)
Parameter
No.
F42/A14
F04/A02
F05/A03
P02/A16
P03/A17
P06/A20
F03/A01
F07
F08
Vector Control (With/without Speed Sensor) (Induction Motor)
Parameter
No.
F42/A14
M1 Series Standard Type User's Manual (I669)
Function name
1st Drive Control Selection/2nd
Drive Control Selection
1st Base Frequency/2nd Base
Frequency
1st Rated Voltage at Base Fre-
quency/2nd Rated Voltage at
Base Frequency
1st Motor Capacity/2nd Motor
Capacity
1st Motor Rated Current/2nd
Motor Rated Current
1st Motor Armature
Resistance/2nd Motor Armature
Resistance
1st Maximum Output Frequen-
cy/2nd Maximum Output Fre-
quency
1st Acceleration Time 1
1st Deceleration Time 1
Function name
1st Drive Control Selection/2nd
Drive Control Selection
6 Vector Control and Applied Functions
Set data
1: IM Dynamic torque vector control
5: IM Vector control without speed sensor
Motor rated value
When rotation tuning can be performed,
this does not need to be set.
When rotation tuning is not possible, either
set the values given in the test report for
the motor, or set the value calculated by
the following formula.
2 2
(P03) -(P55)
Design specification value
Set data
4: IM Dynamic torque vector control with
speed sensor
6: IM Vector control with speed sensor
Default data
0
50.0 Hz
Dependent on
capacity
Dependent on
capacity
Dependent on
capacity
Dependent on
6
capacity
60.0 Hz
6.0 s
6.0 s
Default data
0
6-7