Installation Overview - Nortel Communication Server 1000 Series Manual

Fiber remote multi-ipe interface fundamentals
Table of Contents

Advertisement

7.
8.
9.

Installation overview

The Remote IPE service over a fiber-optic link can be added to an existing
system originally installed and operating without Remote IPE, or it can be
an integral part of a newly installed system.
To install a new system or expand an existing one, refer to Communication
Server 1000M and Meridian 1 Large System Installation and
Commissioning (NN43011-310) () . It provides the information on how to
install, verify, and maintain Large Systems.
Adding one or more Remote IPE sites to a system is treated as a
straightforward system expansion; that is, the system should be fully
operational before the Remote IPE equipment is installed and connected.
This simplifies installation and fault isolation during installation.
To complete the installation of a Remote IPE site, do the following:
Copyright © 2007-2009 Nortel Networks
.
"Installing the internal cables to the Remote IPE module" (page 76)
"Setting S1 and S2 switches at the remote site" (page 77)
Connect the external cables to the I/O panel. Refer to the following:
"Installing superloop cables" (page 82)
"Connecting the system monitor cable" (page 83)
"Connecting the MMI terminal" (page 84)
"Connecting the fiber-optic link to the Remote IPE Module" (page
86)
Configure the Remote IPE local and remote sites. Refer to the
following:
"Configuring the cards" (page 90)
"Selecting the MMI terminal modes" (page 94)
"Configuring the MMI modem" (page 96)
"Configuring the Fiber Remote Multi-IPE Interface" (page 98)
Conduct system acceptance testing. Refer to
testing" (page
103).
perform the preinstallation procedures to prepare the site
install the Fiber Remote Multi-IPE Interface and fiber-optic link
install the copper cables between the Fiber Remote Multi-IPE Interface
units and the local system and between remote Fiber Remote Multi-IPE
Interface units and the Remote IPEs.
Nortel Communication Server 1000
Fiber Remote Multi-IPE Interface Fundamentals
NN43021-556 03.01
11 May 2009
Installation overview 41
"Remote IPE acceptance

Advertisement

Table of Contents
loading

This manual is also suitable for:

Communication server 1000e cp piiCommunication server 1000e cp pivCommunication server 1000e cp pmCommunication server 1000m single group cp piiCommunication server 1000m single group cp pivCommunication server 1000m multi group cp pii ... Show all

Table of Contents