Nortel Communication Server 1000 Series Manual page 62

62 Installation and configuration
Procedure 9
Connecting a single Fiber Remote Multi-IPE Interface to the system monitor
Step
1
2
Connecting multiple Fiber Remote Multi-IPE Interface units to
the system monitor
To daisy-chain the system monitor cables to multiple Fiber Remote
Multi-IPE Interface units, refer to
connections at the local site" (page 63)
10 "Connecting multiple Fiber Remote Multi-IPE Interface units to the
system monitor" (page
Procedure 10
Connecting multiple Fiber Remote Multi-IPE Interface units to the system
monitor
Step
1
2
3
4
5
Copyright © 2007-2009 Nortel Networks
.
Action
Plug one end of the NT8D46AP cable 6-pin modular plug into the
J6 jack of the system monitor in the pedestal.
This system monitor can be the master or an upstream system
monitor towards the master system monitor.
Plug the other end of the NT8D46AP cable 6-pin modular plug
into the XSM IN (J5) modular jack on the Fiber Remote Multi-IPE
Interface unit.
62).
Action
Plug one end of the NT8D46AP cable 6-pin modular plug into
the 6-pin modular jack J6 on the system monitor card in the local
pedestal.
Plug the other end of the NT8D46AP cable 6-pin modular plug
into the first Fiber Remote Multi-IPE Interface unit 6-pin modular
jack XSM IN (J5).
Plug one end of the NT8D46AL (or an equivalent cable) cable
6-pin modular plug into the first Fiber Remote Multi-IPE Interface
unit 6-pin modular jack XSM OUT (J6).
Plug the other end of the NT8D46AL cable 6-pin modular plug
into the second Fiber Remote Multi-IPE Interface unit 6-pin
modular jack XSM IN (J5).
Plug one end of the NT8D46AL cable 6-pin modular plug into the
second Fiber Remote Multi-IPE Interface unit 6-pin modular jack
XSM OUT (J6).
Nortel Communication Server 1000
Fiber Remote Multi-IPE Interface Fundamentals
NN43021-556 03.01
11 May 2009
--End--
Figure 10 "System monitor daisy-chain
and follow the steps in Procedure