Nortel Communication Server 1000 Series Manual page 97

To configure the modem parameters using a character string or a
dip-switch, where applicable, follow the steps in
the modem parameters" (page
Procedure 28
Configuring the modem parameters
Step
1
2
3
4
5
Figure 14 "TTY or terminal modes at the local and the remote sites" (page
98)
from one mode to the next. The three modes are Initial, MMI, and SDI.
The words shown along the paths must be entered on the terminal to go
from one mode to the next.
Copyright © 2007-2009 Nortel Networks
.
Configuring the Fiber Remote Multi-IPE Interface unit 97
Action
Set baud rate by sending the AT<cr> command to the modem
at the desired baud rate.
This sets the modem baud rate. If the modem is already set with
no echo or result codes, the modem does not reply back to the
terminal the result of the command action.
Set auto-answer to ON.
If the modem has a dip-switch, set switch position #5 to the UP
position, otherwise type ATS0=1&W0&Y0<cr>.
Set carrier loss delay to 5/10 second or less.
Type ATS10=5<cr>. This sets a hang-up time of 1/2 second
upon loss of carrier.
Disable local echo.
If the modem has a dip-switch, set switch position #4 to the
DOWN position. Otherwise, type ATE0&W0&Y0<cr>.
Disable result codes.
If the modem has a dip-switch, set switch position #3 to the UP
position. Otherwise, type ATQ1&W0&Y0<cr>.
shows modes that a terminal can be in and paths taken to transition
Nortel Communication Server 1000
Fiber Remote Multi-IPE Interface Fundamentals
NN43021-556 03.01
11 May 2009
Procedure 28 "Configuring
97).
--End--