Nortel Communication Server 1000 Series Manual page 107

5
6
7
8
9
10
11
Repeat this test for telephones connected to different subscriber loops on
the same line card or for different subscriber loops on different line cards in
the Remote IPE module. Making these calls generates traffic, which will be
shown in the traffic report.
Checking the MMI terminal operation
Connect an MMI terminal to the Fiber Remote Multi-IPE Interface unit at
the local site and another MMI terminal to the Fiber Remote Multi-IPE
Interface at the Remote IPE site.To check the MMI terminal operation,
follow the steps in
(page
Procedure 31
Checking the MMI terminal operation
Step
1
2
3
4
5
Copyright © 2007-2009 Nortel Networks
.
Complete this outgoing call by first checking the voice clarity in
both directions, and hang up.
Have another telephone call while the first call is still on hold.
Answer the incoming call and place it on hold.
Retrieve the call first held.
Complete the call and hang up.
Retrieve the second call on hold.
Complete the call and hang up.
Procedure 31 "Checking the MMI terminal operation"
107).
Action
Set the current mode of the MMI terminal to MMI mode by
logging on and by entering L or L xx, where xx is the Fiber
Remote Multi-IPE Interface address in a multiple unit daisy-chain
configuration.
Enter the password FIBER in solid caps.
Check the status of near-end superloops and the fiber-optic link
by executing the D S [P] command.
Check the status of the superloops and the fiber-optic link at the
far-end by executing the D S D command.
This command is sent over the fiber-optic link to the Peripheral
Controller card for execution.
Check the response to this command for the local and remote
sites.
Nortel Communication Server 1000
Fiber Remote Multi-IPE Interface Fundamentals
NN43021-556 03.01
11 May 2009
Performing acceptance testing 107
--End--